Q: How to amplify 15uV, 1.5MHz signal to read on Scopemeter

[Daniel Mandic]

** Fraulein " Suzy the Net Kop " is likely the Austrian one.

Uncle Adolph would be proud of the dumb a dog shit NAZI slut.





...... Phil

;-) what have you deserved??? You were not even on Earth when all that
happened.

Be Quiet and talk rather about Electronix. It seems there you know more
about.

It is no need for AntiNazi Time, yet. Weak coward ))) instigator
))



Best Regards,

Daniel Mandic

 

[Suzy]

Australian, I think...

 

[John Fields]

AUS (Australia), AUT (Austria).

 

[Jamie]

Phil Allison wrote:




latinic fucktard

crawl back to your moronic earth-hole )))))


You make me laugh , you are fooni.

"foonie" = "phony"

(when your comments show your electronic judiciousness,
)))))))))))))))



Keep on Clown.



Best Regards,

Daniel Mandic

You're getting better.

 

[Jamie]

Phil Allison wrote:





;-) what have you deserved??? You were not even on Earth when all that
happened.

Be Quiet and talk rather about Electronix. It seems there you know more
about.

well, that's a matter for opinion

 

[Rich Grise]

On Sat, 27 Oct 2007 00:28:24 +1000, "Phil Allison" [the usual]
Can't figure out how I abused you, but I appreciate your advice
anyway.

Don't worry about Jim - he flames everybody.

Thanks, Rich.

I've been flamed before, and I'll be flamed again. The price paid for
needing help, I suppose.

Booy, do I feel stupid! I meant "Don't worry about _PHIL_! - _HE_ flames
everybody." I must have had the other Jim on my mind at the time, albeit
he's no Phil. ;-)

Sorry if there was any misunderstanding.

Thanks,
Rich

 

[JimG]

Booy, do I feel stupid! I meant "Don't worry about _PHIL_! - _HE_ flames
everybody." I must have had the other Jim on my mind at the time, albeit
he's no Phil. ;-)

Sorry if there was any misunderstanding.

No misunderstanding - I took your comment as you intended.

Ultimately, I was successful in accomplishing my objective using my
little homespun pre-amp. That is, I got my calibrator calibrated.

But I have a couple of low noise LT1037 op amps on the way from
DigiKey. This was one of the several helpful suggestions I received.

I also plan to try cascading a couple of LF411's. I have a few more
10K pots on the way, too, to assist with offset voltage adjustment.

Just in case you wanted an update ;-)

Jim