PCB building

[Sadlercomfort]

This board was ordered by Sadlercomfort which i thank.

Great board my friend! Thank you for the speedy delivery =)

 

[HellasTechn]

You are most welcomed !

 

[HellasTechn]

Merry Cristmas !

 

[Martaine2005]

καλά Χριστούγεννα

Martin

 

[HellasTechn]

Happy New Year !

 

[Dave Benemerito]

Hi there! I'm 13 years old. I wanted to make my prototype for my project for my home automation bla bla.. Hehe. I just wanted to ask if how much would it cost to fabricate one from you? What will I need? And how about the shipping? Thanks

 

[HellasTechn]

Welcome to Electronicspoint
The price depends mostly on the Board size. I do not charge extra for shipping. pm me for more details !

Thank you and happy new year !

 

[Dave Benemerito]

Welcome to Electronicspoint
The price depends mostly on the Board size. I do not charge extra for shipping. pm me for more details !

Thank you and happy new year !

Hi! Happy new year to! lets say its a 5 inches X 3 inches which is double sided. What if also if it is just single sided. Also, how much time would it take to ship to Philippines? Hehe Thanks! :-D

 

[HellasTechn]

About ship time to Philippines it would take about 20 days. About the rest i will check and let you know !

 

[Sadlercomfort]

I will start soldering and finishing off my project on the PCB you made me Constantine

Hopefully upload a picture by the end of this week.

Thanks Again!

 

[HellasTechn]

Thank you !
I am always at your disposal !

 

[HellasTechn]

Video signal converter board.

 

[HellasTechn]

Static RAM 256K PCB.

Trace width: 0.38mm

Clearance around traces and pads: 0.30mm

I made this board for fun, so that anyone can actually activate, read and write data from and to chips addresses and see the output visually through LED.

For setting address and input as well as Chip select, write enable and read enable i use rows of pins with jumpers.

 

[HellasTechn]

Almost done here with this board !

 

[HellasTechn]

All done with this one.

 

[HellasTechn]

Thank you very much.
Actually i now practice a different way of making the "Component's Location Layer" that is better. I will demonstrate it next board i make.

 

[HellasTechn]

This is a TDA2005 Power amplifier board.
Its size is 4cm x 3cm (1.57in x 1.18in)

Trace width is 0.38cm (0.14in)

 

[chopnhack]

Good job Constantine!! That is a really small board, good detail too. When are you going to post some pics of the new component location or silkscreen??

 

[HellasTechn]

Thank you.
I will in the near future because at the moment i am up to my ears with the familly and work

 

[HellasTechn]

Here it is complete.