Maker Pro
Maker Pro

xenon lamp trigger

Hi,

a confirmation to avoid the worst ...

To change the lamp, I have to desolder the wires from the lamp and the trigger transformer ...

the only thing I did not remember, the common trigger wire if it was combined with the positive or negative of the lamp

and so I had to get the wiring diagram to understand!

Question: the common trigger transformer, given the scheme that I got, must be connected on the positive lamp ... right?

Attachments
 

Attachments

  • TRIGGER_WIRE.jpg
    TRIGGER_WIRE.jpg
    95.4 KB · Views: 17
Presumably you're talking about the 'straight red line'? This usually wraps around the xenon tube and doesn't actually connect to anything on the tube itself.
 
yes I know, in fact the wire wraps the tube of the lamp ...

I mean the trigger common, should it be connected to the lamp's positive as circled with red in the scheme?
 
Top