So ball bearing tilt switches aren't cutting it because I am working on a full access sphere range. And I've given up on looking
So my thoughts were to make a cube of acrylic tiles where I paint spots with melted solder (each spot I'll use a tiny hand held drill to make a small hole, where there's a copper wire attached to the solder.. Then hanging a ball of metal solder from the top suspended by twine, where the twine is wrapped by a very thin copper wire.
Am so new at this ... would love any thoughts, experience, etc, that I can gather. Am new to this. Ball bearing switches are cheap. If I can make this on the cheap...great.
If there's one out there for $25, forget about it.
Sorry for the vague post....
Thanks ahead all,
Sergio
So my thoughts were to make a cube of acrylic tiles where I paint spots with melted solder (each spot I'll use a tiny hand held drill to make a small hole, where there's a copper wire attached to the solder.. Then hanging a ball of metal solder from the top suspended by twine, where the twine is wrapped by a very thin copper wire.
Am so new at this ... would love any thoughts, experience, etc, that I can gather. Am new to this. Ball bearing switches are cheap. If I can make this on the cheap...great.
If there's one out there for $25, forget about it.
Sorry for the vague post....
Thanks ahead all,
Sergio