So, many of you will know that I am a novice who is like a 2 year old with questions, when it comes to electronics ;-)
I thought I'd share a tip; for novices.
Building a circuit is exciting. If you're like me, you can't wait to make your next solder connection so you can see the magic unfold.
But, having been in that situation, I began noticing that some of my solder joints were breaking; especially when I was forced to cram them.
So, now, here is what I do.
I have a coffee with me. I am also wearing a Covid mask while soldering- I figure, I have now gotten used to wearing a mask everywhere, so why not use it as an extra layer of protection for not breathing in fumes.
Anyway, my new method is: I make the solder connection. I remove my mask. I take a sip of coffee. Then I make the next connection. This forces me to allow enough time for the solder joint to completely dry and form a better bond. It's made a difference, believe it to not.
I suspect it will work with tea, But I'm not sure if it would be a good idea with Jack Daniels, bourbon or beer. ;-)
I thought I'd share a tip; for novices.
Building a circuit is exciting. If you're like me, you can't wait to make your next solder connection so you can see the magic unfold.
But, having been in that situation, I began noticing that some of my solder joints were breaking; especially when I was forced to cram them.
So, now, here is what I do.
I have a coffee with me. I am also wearing a Covid mask while soldering- I figure, I have now gotten used to wearing a mask everywhere, so why not use it as an extra layer of protection for not breathing in fumes.
Anyway, my new method is: I make the solder connection. I remove my mask. I take a sip of coffee. Then I make the next connection. This forces me to allow enough time for the solder joint to completely dry and form a better bond. It's made a difference, believe it to not.
I suspect it will work with tea, But I'm not sure if it would be a good idea with Jack Daniels, bourbon or beer. ;-)