I would like to start by saying I am no professional in electronics at all. I have soldered a few kits but that is the extent of it.
Would it be asking to much for someone to draw up a schematic for me or can I buy something like this already made?
I am building a project that I want a 1 gallon tank to heat up to roughly 80°,then a pump (pressure would be would like kitchen faucet) would turn on for a minute, that pump turns off and another pump with a gallon on heated water will turn on for a minute and 30 seconds, then it shuts off and a blower fan will turn on for 2 minutes. Is this asking a lot or can it be done? Its kinda like a dish washer would work.
Thanks, Randy
Would it be asking to much for someone to draw up a schematic for me or can I buy something like this already made?
I am building a project that I want a 1 gallon tank to heat up to roughly 80°,then a pump (pressure would be would like kitchen faucet) would turn on for a minute, that pump turns off and another pump with a gallon on heated water will turn on for a minute and 30 seconds, then it shuts off and a blower fan will turn on for 2 minutes. Is this asking a lot or can it be done? Its kinda like a dish washer would work.
Thanks, Randy