D
darkstar
The system consists of a GEM-P3200 and a GEM-RP1CAe2 Keypad. While
attempting to clear the Dealer Program to correct a previous error,
something occurred that now prevents me from accessing the Address
Program Mode. Everything seems to work fine when entering the Dealer
Program Mode. Once there I press the <reset> key to enter the Address
Program Mode and then the access location {in this case 4091}. All
this does is to change the displayed item(s) in the Dealer Mode. It
seems to never enter the Address Mode. Does anyone have a clue as to
how this can be remedied? I am going to try leaving the power off for
a bit to see just how much programming will disappear. Any help is
most appreciated. Thanks!
attempting to clear the Dealer Program to correct a previous error,
something occurred that now prevents me from accessing the Address
Program Mode. Everything seems to work fine when entering the Dealer
Program Mode. Once there I press the <reset> key to enter the Address
Program Mode and then the access location {in this case 4091}. All
this does is to change the displayed item(s) in the Dealer Mode. It
seems to never enter the Address Mode. Does anyone have a clue as to
how this can be remedied? I am going to try leaving the power off for
a bit to see just how much programming will disappear. Any help is
most appreciated. Thanks!