Maker Pro
Maker Pro

Custom Flash Speed for Genesis [Fire Alarm] Strobe?

I was gifted a handful of these units, with adjustable 15-90cd strobe brightness, and want to use them in a project, but they are only a 1 Hz strobe rate, and I want 10 Hz or higher.

They are 24V and offer no way to alter the default strobe rate. Anyone have ideas? I am considering running the strobes on individual circuits, each with a very slight delay on powering up, but am not sure how this is best achieved.
 
T

Tom Biasi

I was gifted a handful of these units, with adjustable 15-90cd strobe brightness, and want to use them in a project, but they are only a 1 Hz strobe rate, and I want 10 Hz or higher.

They are 24V and offer no way to alter the default strobe rate. Anyone have ideas? I am considering running the strobes on individual circuits, each with a very slight delay on powering up, but am not sure how this is best achieved.
They probably won't strobe at 10 Hz. with the stock capacitor. The
circuit may be difficult to access and modify also.
Maybe you will need to build your own trigger circuit inside the unit.

Tom
 
J

Jamie

Tom said:
They probably won't strobe at 10 Hz. with the stock capacitor. The
circuit may be difficult to access and modify also.
Maybe you will need to build your own trigger circuit inside the unit.

Tom
SOunds like a candidate for a simple negative resistance npn LED flasher..

Jamie
 
J

Jasen Betts

I was gifted a handful of these units, with adjustable 15-90cd
strobe brightness, and want to use them in a project, but they are
only a 1 Hz strobe rate, and I want 10 Hz or higher.

you probably need to reduce the size of the strobe capacitor by a
factor of 10.

this will reduce the intensity but boost the frequency.
 
Top