Bare board test acceptable yield

[Greg Neff]

I remember seeing a requirement somewhere (maybe in an IPC standard?)
that has a requirement along the lines of "if x% of bare printed
boards fail bare board testing (shorts and continuity) then the entire
lot shall be rejected". Can anyone point to a standard on this?

================================

Greg Neff
VP Engineering
*Microsym* Computers Inc.
[email protected]

 

[Active8]

I remember seeing a requirement somewhere (maybe in an IPC standard?)
that has a requirement along the lines of "if x% of bare printed
boards fail bare board testing (shorts and continuity) then the entire
lot shall be rejected". Can anyone point to a standard on this?

================================

Greg Neff
VP Engineering
*Microsym* Computers Inc.
[email protected]

Try www.ipc.org and google.

 

[Greg Neff]

Try www.ipc.org and google.

Been there, done that. We are a member of IPC and we have the IPC
standards here (many binders full of stuff), but I couldn't put my
finger on anything. I don't think it was an IPC document I was
looking at. I wish I could remember where I read this...

================================

Greg Neff
VP Engineering
*Microsym* Computers Inc.
[email protected]