R3 reading of 0.085 is too low, that makes Q2 a suspect.
Can you please confirm that reading?
If it confirms ,then de-solder Q2 ,take it out and measure it in Diode Mode.
Note Q2 connections on the board before you take it out.
Check between B-E and B-C and C-E and flip (a total of 6 measurements).
on the capacitors:
The Capacitors you bought are from Marcon ,a good Japanese company(if genuine).
But,the date code is very old 1992 ...
In fact, that company was bought by another firm somewhere in the mid 90's.
Is there any way you can check capacitance and ESR somehow elsewhere?