Hello All,
I have a hot air balloon chase vehicle RV. I am planning to use a baby monitor to provide listening intercom from the salon in my RV to my driver position. I have the portable battery receiver unit to mount next to the driver. This portable piece is driven by a 9Vbattery. I plan on hard mounting the transmitter over the sofa in order to hear conversations behind my driver position. I will be able to participate in the conversations by being able to understand more clearly any questions,.
My dilemma is that the transmitter has no 9V battery compartment but uses a 12v plug in power supply, I want to hard wire to my 12 volt RV system. What components will I need to solder in line to reduce the voltage to 9VDC.
Any assistance you can offer is greatly appreciated.
Buoyantly
Professor Bob
I have a hot air balloon chase vehicle RV. I am planning to use a baby monitor to provide listening intercom from the salon in my RV to my driver position. I have the portable battery receiver unit to mount next to the driver. This portable piece is driven by a 9Vbattery. I plan on hard mounting the transmitter over the sofa in order to hear conversations behind my driver position. I will be able to participate in the conversations by being able to understand more clearly any questions,.
My dilemma is that the transmitter has no 9V battery compartment but uses a 12v plug in power supply, I want to hard wire to my 12 volt RV system. What components will I need to solder in line to reduce the voltage to 9VDC.
Any assistance you can offer is greatly appreciated.
Buoyantly
Professor Bob