Sony KV27TS29 Sides Bow In

[gymsurely]

It looks like the problem is IC501 (TDA8172). Does this make sense? The
picture returns to normal if I tap the part. I'm not an electronics
person but I'm tempted to buy a part and replace it.

 

[Ross Herbert]

It looks like the problem is IC501 (TDA8172). Does this make sense? The
picture returns to normal if I tap the part. I'm not an electronics
person but I'm tempted to buy a part and replace it.

first, check for dry joints in the area around the IC. It might be
that simple....

 

[Andy]

and the capacitors in this area,which may have dried up

 

[[email protected]]

It looks like the problem is IC501 (TDA8172). Does this make sense? The
picture returns to normal if I tap the part. I'm not an electronics
person but I'm tempted to buy a part and replace it.

It must be some part nearby, maybe even mounted on the same aluminum
plate, but definitely not this IC. Your error is in the E/W circuit,
this IC handles vertical deflection. Most of the time the E/W regulator
transistor or some related coils will have bad solder connections.

 

[gymsurely]

I reflowed and/or added some solder on about 12 pins around the IC. All
looks well again.

Thanks

 

[b]

It looks like the problem is IC501 (TDA8172). Does this make sense? The
picture returns to normal if I tap the part. I'm not an electronics
person but I'm tempted to buy a part and replace it.

i recall repairing a kv27ex about 3 years ago with this condition.
there was a geometry daughterboard at the rear of the main pcb which
had dry joints where it joined the main pcb. I also cleaned all the
pots on it to be sure.

hope this helps, Ben