Maker Pro
Maker Pro

Small rs232 RC 4 servo with PIC 16F648 for webcam control etc..

S

Si Ballenger

I'v put the first complete version (most commands implemented)
on the site.


http://www.home.zonnet.nl/panteltje/pic/camc_pic/

I haven't been successful yet in programming a PIC as a servo
controller, but do have a simple way to control one via the net
that might be of interest. The below links have two ways to make
the pan/tilt control panel with out special programming.

http://www.geocities.com/zoomkat/ppswitcher-demo.htm
http://www.geocities.com/zoomkat/ppswitcher-demo1.htm
 
Top