Maker Pro
Maker Pro

Simple Circuit Design Help

Hey guys,

I'm new to the forum and fairly new to electronics, I am trying to design a circuit to have a DC output of 12V.

I have been given a 36V DC source and the 3 resistors with the below resistivity:

1kOhm
4kOhm
4kOhm

Does anybody have any simple circuit designs that would produce the 12V output or any help would be greatly appreciated :)

Cheers,
C
 

Harald Kapp

Moderator
Moderator
Think of the ratio of the required DC output to the available DC input. There is a very simple and basic resistor circuit that comes to mind ...
 
Sorry for the late reply guys, many apologies for posting in the wrong thread.

I think I have solved it... see attached?

Pretty sure that'd work, what do you guys think?
 

Attachments

  • circuit.jpg
    circuit.jpg
    22.5 KB · Views: 84

Harald Kapp

Moderator
Moderator
Your drawing is a bit unusual in that ground (0 V) is on top, but otherwise that's exactly what I had envisioned.
 
Cool, thank you :)

Would there be a better place to connect the ground? Or does it not really matter so long as the ground is attached at some point in the circuit?

Cheers
 

Harald Kapp

Moderator
Moderator
Would there be a better place to connect the ground?
Physically it doesn't matter.
By convention ground is usually connected to 0 V and placed near the bottom, positive supply near the top. Just have a look at some schematics e.g. on the internet or in your textbooks.

You can find different uses, too. E.g. when you're working with negative supply voltages where ground would be connected to the positive supply.

Here's a discussion of this topic you may want to read.
 
Top