D
Dave S
Dave S had written this in response to
http://www.secure-gear.com/alt.security.alarms/5/-article-.htm :
Goldendomers
-------------------------------------
I have an ADT Safewatch pro 2000 installed when I built my house in 1999.
I purchased the equipment. After 2 year I stopped the monitoring. I had
two magnetic sensors go bad. I have been able to replace one and I would
like to by-pass the second one for now.
When I look at the keypad all zones are functioning except the one bad
zone. When I by-pass that zone and set the alarm several areas when I
test will not set the alarm off. I.e. when I open a window or door.
Out of 8 Zones I would say 3 seem to be functioning properly.
Any ideas what may be wrong??
##-----------------------------------------------##
Delivered via http://www.secure-gear.com
The Internet Knowledge Base for the security industry
no-spam access to your favorite newsgroup -
alt.security.alarms - 43410 messages and counting!
##-----------------------------------------------##
http://www.secure-gear.com/alt.security.alarms/5/-article-.htm :
Goldendomers
-------------------------------------
I have an ADT Safewatch pro 2000 installed when I built my house in 1999.
I purchased the equipment. After 2 year I stopped the monitoring. I had
two magnetic sensors go bad. I have been able to replace one and I would
like to by-pass the second one for now.
When I look at the keypad all zones are functioning except the one bad
zone. When I by-pass that zone and set the alarm several areas when I
test will not set the alarm off. I.e. when I open a window or door.
Out of 8 Zones I would say 3 seem to be functioning properly.
Any ideas what may be wrong??
##-----------------------------------------------##
Delivered via http://www.secure-gear.com
The Internet Knowledge Base for the security industry
no-spam access to your favorite newsgroup -
alt.security.alarms - 43410 messages and counting!
##-----------------------------------------------##
