Hi,
I have project to control DC motor to replace the manual parking brake in the four wheeler. To develop a prototype I have decided to use a labview software communicating with the microcontroller. My intention is that I need to read one of the analog inputs continuously where the motor current signal will be connected at the same time set the forward and reverse motor current limits from the labview.
I know this is not possible with the serial communication. I would like to know whether this can be achieved using TCP/IP so that I can display the motor current continuously in the graphical representation as well as set the current limits from the labview.
If this is possible, pls help me with the controller number, if possible with the simple microcontroller code.
Regards,
X. Ignatius
I have project to control DC motor to replace the manual parking brake in the four wheeler. To develop a prototype I have decided to use a labview software communicating with the microcontroller. My intention is that I need to read one of the analog inputs continuously where the motor current signal will be connected at the same time set the forward and reverse motor current limits from the labview.
I know this is not possible with the serial communication. I would like to know whether this can be achieved using TCP/IP so that I can display the motor current continuously in the graphical representation as well as set the current limits from the labview.
If this is possible, pls help me with the controller number, if possible with the simple microcontroller code.
Regards,
X. Ignatius
