Maker Pro
Maker Pro

Newbie needs assistanse

Hi good people of electronicspoint.

I`m curently buildin a kegorator, and have bought two SF800 flow meters, (As i thought i wolud be plug and play) According to the scematics attached i need to rig some resistors (Wich i have bought now) But as the noob i am i cant figure out how to connect this to a breadboard and up to my Photon.. Could some one please give me advice or even better a suggestion on how to implement this into a cable that goes to my Particle board. I know this is electronics 101 question, but i know beer and not electronics.

https://developer.mbed.org/cookbook/SF800_flowmeter

[Mod Note: fixed link]
 
Last edited by a moderator:
Can you post a picture of the unit - there should be three visible terminals or wires according to the drawing.

Have you any previous experience using breadboards?
 
Top