Maker Pro
Maker Pro

Need help programming RCA SystemLink 4 remote

K

Ken_B

I have a SystemLink 4 remote, and need to control an A/V receiver. The
instruction book has a list of audio codes, but the instructions are screwed
up.

The only device buttons are TV, VCR, Satellite, and AUX. Instructions say
audio devices can be assigned to AUX.

Instructions for assigning other devices to AUX say press and hold Code
Search Button until light comes on, then press AUX, after which the light
will blink and stay lit. Then the instructions say to PRESS THE BUTTON FOR
THE DEVICE you want to program. But there is NO AUDIO BUTTON!

I've tried just pressing AUX then putting in audio codes, but nothing works.
Tried on three different brands of A/V receivers.

Anybody know how to make this remote work audio? Thanks.
 
S

sofie

Ken B:
The instructions are correct....... AUX is the "audio" button. More than
likely the codes listed in your instructions are not inclusive of the
equipment you want to control..... have you tried the "auto-search" to find
a possible code? Look in your instructions...... it will require that the
equipment be turned on and multiple presses of the remote control power
button to find a proper code...... refer to your instructions for the
proper button sequence.
As a final note.... it is possible that you may need a factory original
remote to control your A/V receiver.
 
K

Ken_B

I tried the search function to no avail. Guess you're right about me needing
the original remote. Thanks.

Ken
 
Top