I am fairly familiar with dc wiring. i am making an independent trim system for a jet ski conversion build. i need to wire it according to the requirements below. trying to find service documents for the system before i cut up to make it. i don not know if i should use two relays or just use switch no relays. 12v power source. I flushed like $500 with my previous attempt, so am requesting some help first this time.
3 wire switch, 3 pos: up, off, down
up and down limiters
position sensor
position sensor readout( will find one thats fits sensor readout range)
i will post more tonight once i have more info, but just wanted to get this out there in case anyone who is good at this stuff is browsing and has any suggestions. thank you for your time
ATTACHMENTS
Generic_Motor_Switch.jpg (21.25 KiB) Viewed 3 times
MOTOR_SPEED_CONTROL_12V_APP_2.jpg (39.52 KiB) Viewed 3 times
images.png (2.81 KiB) Viewed 3 times
3 wire switch, 3 pos: up, off, down
up and down limiters
position sensor
position sensor readout( will find one thats fits sensor readout range)
i will post more tonight once i have more info, but just wanted to get this out there in case anyone who is good at this stuff is browsing and has any suggestions. thank you for your time
ATTACHMENTS
Generic_Motor_Switch.jpg (21.25 KiB) Viewed 3 times
MOTOR_SPEED_CONTROL_12V_APP_2.jpg (39.52 KiB) Viewed 3 times
images.png (2.81 KiB) Viewed 3 times