microphone too hot - can I just insert a resistor?

[tempus fugit]

each should
Thanks Tim

The mic is being plugged into a mic input that is expecting to see a low
impedance into it (in the 200 - 600 ohm region I would think). So would my
parallel resistor be around 600 ohms? Also, does the value of the pad
(series) resistors affect what the value of the parallel resistor should be?
The series resistors will be in the 10K - 15K range by the looks of things.

Thanks

Wait a minute - I just found this page that explains everything nicely:

http://www.uneeda-audio.com/pads/