Maker Pro
Maker Pro

looking for a 10 bit transceiver with latches?

Hello,

I have found this part at:

http://www.ti.com/lit/ds/sccs035a/sccs035a.pdf

which is a unidirectional 10 bit latch with 3 state outputs employing two enables of which I require in my design.

I was wondering though, is there any parts out there that have the same thing but bidirectional?

I have been looking everywhere on the Internet for a few days and can't seem to find anything :mad:

If anyone has ever used such a part I would really appreciate the part number :)

PS probably a part with such functionality would make
No sense ... I guess is why I can't find it. :rolleyes:

Thank you all
 
Last edited:
Yeah thanks Steve I appreciate your reply.

however I really do need the 10 bits....

I have been looking all over the place and could not
Find it.

I just think I will get myself a 2.00$ CPLD and
Do it myself .

Cheers and thanks for replying
 

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
If you were to look hard enough, you'd probably find the same thing but 16 bits wide, but it would probably cost more than $2 in small quantities and be in a nasty package :)

Like this.
 
Top