Hi,
I've recently got the Laird BTM511 pcb mount bluetooth module. So I've looked at the hardware pdf (http://www.elhurt.com.pl/wireless/f...df?PHPSESSID=cbf7ad8f8d00367ed557a32d0e796446) and saw an intense circuit schematic for a development board for the manual.
Now, I only need this module to connect with an microcontroller over UART and send data (not all the speaker and microphone capability). So I want to create a very simple pcb schematic to mount the module on, and interface (UART) between the module and a microcontroller.
Has anybody worked with these modules before, or can give me a few pointers? Just need to make sure I'm not missing stuff like decoupling capacitors, resistors etc.
Thanks
I've recently got the Laird BTM511 pcb mount bluetooth module. So I've looked at the hardware pdf (http://www.elhurt.com.pl/wireless/f...df?PHPSESSID=cbf7ad8f8d00367ed557a32d0e796446) and saw an intense circuit schematic for a development board for the manual.
Now, I only need this module to connect with an microcontroller over UART and send data (not all the speaker and microphone capability). So I want to create a very simple pcb schematic to mount the module on, and interface (UART) between the module and a microcontroller.
Has anybody worked with these modules before, or can give me a few pointers? Just need to make sure I'm not missing stuff like decoupling capacitors, resistors etc.
Thanks