I've been trying to put a paper design on a bread board and not getting through

[Nwanno Promise]

I've been trying to put a paper design on a bread board and not getting through. Precisely, I want to create an amplifying system with a mosfet transistor I already have (50N06), looked up for details of the transistor online. Basically, my problem is that I was expecting to find approximately zero voltage across the gate resistor (Rg) but it appears to be taking away all my D.C Volatage and leaving the drain resistor (Rd) with none- I'm using the drain feedback method of bias. please the smallest possible help and suggestion is appreciated

 

[davenn]

welcome


so show us your circuit diagram

 

[(*steve*)]

And, if possible, a photo of your breadboard so we can see what you've done.