is there a circuit diagram and program that can make my arduino communicate and reprogram the signal in the eeprom cartridge input of the ensonic SD1 cartridge storage?
The reason I need this is because they don't make blank storcarts anymore, and the system cannot store pitch tables
(synthesizers don't have to play intune... they can make noises that are not intune using pitch tables.)
on anything other than blank storcarts
For you old time ISA and you up and coming cartridge system wizards
storecarts were small form factor ISA plug in cartridges with formatted eeproms on them that stored preset codes that installed in the synth when you wanted them.
I have a couple cartridges with german nightclub sounds on them, but I really don't want to ruin them...
what about a small form factor device with eeprom reader program?
The reason I need this is because they don't make blank storcarts anymore, and the system cannot store pitch tables
(synthesizers don't have to play intune... they can make noises that are not intune using pitch tables.)
on anything other than blank storcarts
For you old time ISA and you up and coming cartridge system wizards
storecarts were small form factor ISA plug in cartridges with formatted eeproms on them that stored preset codes that installed in the synth when you wanted them.
I have a couple cartridges with german nightclub sounds on them, but I really don't want to ruin them...
what about a small form factor device with eeprom reader program?
