J
John_H
Hi
I have a start-up problem with my TDS3014B. It start backlight an
actually the start screen is Ok. It pulses all front leds for a littl
bit and then the 1KHz/5V square wave becomes available. Start scree
remains without change and there is no any diagnostic message
Troubleshooting chart doesn't cover this situation since it only i
useful when diagnostic message apply. It seems to be a softwar
problem rather than electronic problem.
Service from Tek is expensive. I heard about a key sequence to initiat
to factory settings.
I will aprreciate if somebody have an idea to solve this...
Regards
John_
I have a start-up problem with my TDS3014B. It start backlight an
actually the start screen is Ok. It pulses all front leds for a littl
bit and then the 1KHz/5V square wave becomes available. Start scree
remains without change and there is no any diagnostic message
Troubleshooting chart doesn't cover this situation since it only i
useful when diagnostic message apply. It seems to be a softwar
problem rather than electronic problem.
Service from Tek is expensive. I heard about a key sequence to initiat
to factory settings.
I will aprreciate if somebody have an idea to solve this...
Regards
John_