Hi, I just picked up an almost "dead" NEC MultiSync 1700 monitor from
my workplace and was hoping that I could repair by myself and use it
since it's about to be thrown out. Here is the symtpon that I saw on
the monitor:
- Power to the monitor is still working (at constant rate), I've tried
another power supply unit but there seemed to be no problem with power
supply.
- When switched ON, the monitor will show the whole screen for a
fraction of a second and then goes black.
- If I switch the monitor to OFF then ON again, the monitor will
display things again for a fraction of a second as described above.
I'm a newbie to this so any suggestion is greatly appreciated. The
monitor is still under warranty but there's no way that I can find
where the original receipt is. Thanks in advance for your help.
my workplace and was hoping that I could repair by myself and use it
since it's about to be thrown out. Here is the symtpon that I saw on
the monitor:
- Power to the monitor is still working (at constant rate), I've tried
another power supply unit but there seemed to be no problem with power
supply.
- When switched ON, the monitor will show the whole screen for a
fraction of a second and then goes black.
- If I switch the monitor to OFF then ON again, the monitor will
display things again for a fraction of a second as described above.
I'm a newbie to this so any suggestion is greatly appreciated. The
monitor is still under warranty but there's no way that I can find
where the original receipt is. Thanks in advance for your help.
