Hello everyone,
I have a small project to do which is preparing something similar to an automatic emergency light.
I have purchased 2 TP4056 charging circuit boards with two 18650 batteries and a P channel Mosfet.
My load is a 6V LED board. any suggestions on how to do the connections?
I want to try and connect each TP4056 board separately to an 18650 battery ( for charging) with a common 5V input. then the outputs of each board to be connected in series to later lower the voltage to 6V using two resistors 10k and 24k.
Can you please confirm if my circuit will work that way or should I be using some other solution?
I have a small project to do which is preparing something similar to an automatic emergency light.
I have purchased 2 TP4056 charging circuit boards with two 18650 batteries and a P channel Mosfet.
My load is a 6V LED board. any suggestions on how to do the connections?
I want to try and connect each TP4056 board separately to an 18650 battery ( for charging) with a common 5V input. then the outputs of each board to be connected in series to later lower the voltage to 6V using two resistors 10k and 24k.
Can you please confirm if my circuit will work that way or should I be using some other solution?