Maker Pro
Maker Pro

the part of the referenc

Harald Kapp

Moderator
Moderator
If you want to know the type of these parts remove the insulating sleeve and look at the lettering imprinted on these components. Don't forget to replace the insulation afterwards.
 
ok the problem is that this card came from another technician and has not brought these 2 compnentes that are marked on the circuit already sent the photo to the forum
the photo are im top forum
 
If you don't have those parts (where did they go?) there is no chance of identification from that picture, it simply doesn't provide anything that would even give a clue at the identity of the parts ..

If you want to identify that part, you will need to either source another board and reference that board for the part numbers or find (unlikely) a schematic for the board...

Have you contacted the company?
 
No need to keep repeating the model number, you have already been given the best answer we can at this point... Unless someone happens to have the same board in hand and can look at the parts for you, you are simply not going to identify them without help from the manufacture...
 
Top