wtd[perth] Heater/temp. iron from Dick Smith T-2000 soldering base

[Mike]

Hi all,

This is the heater/temperature sensor combo element, mine
is getting a bit flakey - other electronics seem ok but my
temp sensor is intermittent, suspect internal continuity
fault on temperature sensor.

Anyone had one left over from a damaged T-2000 base ?

Havent tried Dick Smith yet,


--
Regards from
Mike, Perth, Western Australia
Email me at address on my general link below
General stuff here: http://www.iinet.net.au/~erazmus
GMH VL fuse box replacement:
http://www.iinet.net.au/~erazmus/car_accessories