bill hill said:
I'm looking for a schematic and parts list for a Weller EC1002 soldering
station. Any help would be greatly appreciated.
Thanks
Bill
BILL -
Much of my Weller documentation is on BAMA Mirror -- LOOK here:
http://bama.edebris.com/manuals/weller/
What do you need?? IF you are trying component repair on the surface mount,
good luck.
IF you have an OLD ceramic board -- look at EC242 -- that will give you some
ideas - from my reverse engineering. The IC was a proprietary Weller design
(I think Signetics made them for CopperTools/Weller)
EC234 - Plug-in heater for EC1201 iron
EC226 - Temperature sensor (Type K Thermocouple) for EC1201 iron
I do have spare EC1002 Control Boards -- reliable Series 3 (fiberglass
boards) I use for restorations/repairs.
EC1002 is a good station -- although Weller had issues with a ceramic
control board approach (trying to prevent Far East copy cat deisgns) in
early models. Approach worked -- copy cats went and copied the Hakko
design!!
g. beat
w9gb