B
Brett Holden
Hello, All!
I am trying to design a PI metal detector. I need some advice on what to do
with unused I/O pins on a quad analog switch. I need to use two sections of
DG411. Now, I know that I could parallel 2X2 gates to use all four sections,
but for the sake simplifying the PCB layout I would prefer not.
My question is: would it be OK to tie unused "D" pins together and unused
"S" pins together - and then ground "D" or "S" through a 10k resistor, or is
there a better way of dealing with this?
I would appreciate any advice.
With best regards, Brett Holden. E-mail: [email protected]
Forgot the t in south
I am trying to design a PI metal detector. I need some advice on what to do
with unused I/O pins on a quad analog switch. I need to use two sections of
DG411. Now, I know that I could parallel 2X2 gates to use all four sections,
but for the sake simplifying the PCB layout I would prefer not.
My question is: would it be OK to tie unused "D" pins together and unused
"S" pins together - and then ground "D" or "S" through a 10k resistor, or is
there a better way of dealing with this?
I would appreciate any advice.
With best regards, Brett Holden. E-mail: [email protected]
Forgot the t in south