TC13B1-T heated blanket controller testing help

[Jeremy Ridler]

The Controller Led Lights Up Red But You Can Not Turn It On Or Increase The Heat Setting I Opened It Up And The Fuse On The Power In Side Is Good What Should I Test Next? Thank You For Your Help I Am New To This forum

 

[(*steve*)]

If the electric blanket doesn't heat up, and if it's a simple switched arrangement, then the blanket has a fault.

Post some photos of the controller so we know what we're talking about. Otherwise we can't really comment (which is why we haven't)

 

[Jeremy Ridler]

Her are some photos of the board. I did ohm out the blanket and it has no breaks in it. I also tried the controller on another blanket we have and it did not work either.

 

[Jagtech]

The majority of failures with these items is a break in the cable where it enters the strain releif on the remote. Do a continuity check of each conductor in the cable before tearing into the electronics. Be sure to disconnect from the blanket when doing the test.

 

[Electric Al]

Her Are Some Photos Of The Board. I Did Ohm Out The Blanket And It Has No Brakes In It I Also Reyes The Controller On Another Blanket We Have And It Did Not Work Either.

If your blanket has no Brakes , how do you stop it from rolling down the hill !

Sorry ! I couldn't resist !

 

[(*steve*)]

Her are some photos of the board. I did ohm out the blanket and it has no breaks in it. I also tried the controller on another blanket we have and it did not work either.

iT mAY bE tHE mOSFET.