Still need help with Amico multi process welder

[Raylicker]

Hi all, do you or could you lead me to a group that can help me get this welder going. I left it on for about an hour and when I got back it was off and never to start again. The power light goes on but nothing else. The switch is good. Only had the thing for 1 year and then one month after the warranty expired it died. Thank you for any help here or point me to another group, I was told there was one that would help with troubleshooting PCB's. I'm getting power to the capacitors but don't know where o check after that. Here are pics of the two boards in it. Could it be on the little board? if I am getting power all the way to the capacitors, shouldn't I have front panel lights or something? Please any help, here are pics of both boards

 

[Bluejets]

Check thermal switch #005 top photo for continuity. (on the heatsink)

 

[Raylicker]

It has continuity

 

[Raylicker]

Here are schematic

 

[Bluejets]

Difficult to follow low resolution......might be just I am trying to view on my phone.
Have a feeling there is (a lot) more to it than shown there though.

 

[Raylicker]

I had to resize it to upload it. I can e-mail you the original pic I have. I know on my phone I can zoom in to see most of the numbers and letters. What do you mean the is a lot more to it, to what?

 

[Tha fios agaibh]

Yes, grainy to see. Take 2 pictures (smaller) with more resolution to keep file size low enough to post.
Have you checked the +5 and +12 power rails with respect to ground here?