Simple Button and Ethernet Interface Schematic

[Bluboy]

Hi, I hope you can help.....

As I am sure you have guessed I am no electronics expert but I have a need for a simple 4 momentary contact button configuration connected to an EDAM 9050 Ethernet Interface. The buttons have LED Illumination.

I have drawn up a simple connection diagram attached. Can anybody verify if this is correct, or most likely what I have done wrong?

Your time is much appreciated.

 

[dorke]

Well,
That depends of is it you like to achieve...
The way you connected it D1-D4 have logic level "0" normally.
pressing the push-button of an input will change that to logic "1" (as long as the button is pressed).
Don't try to count "events" with that connection !!!

 

[Bluboy]

Well,
That depends of is it you like to achieve...
The way you connected it D1-D4 have logic level "0" normally.
pressing the push-button of an input will change that to logic "1" (as long as the button is pressed).
Don't try to count "events" with that connection !!!

Hi, thanks for the response,

What I need to do is register a dedicated input (button push) that is detected by a Crestron control system, the Crestron then spits out its corresponding code to feedback the selected input. i.e. If the user selects option 3 the Crestron will detect the input via the EDAM unit and configure the zone to the predetermined state for input 3. Does this make any sense?