Hi,
About me:
I am rather new to electronics, so please be good to me
(but have some experience).
What am i trying to do:
I want to make this a cheap setup (don't mind the arduino cost) where i can have several transmitters and one receiver.
For example if i want to have a temperature sensor in 2 different places, and want to transmit the temperature to the receiver every hour.
Equipment i currently have:
- Arduino uno
- Arduino mega
- 433Mhz RF Transmitter / receiver (ebay)
- PT2262 (Datasheet1, Datasheet2)
- PT2272-M4 (Datasheet)
- Powersupply (0-30v)
- Breadboards, Wires, multimeters, different resistors, capacitators....etc
What have i already done successfully, and what is the problem?
I have setup the first transmitter and receiver code from here: http://www.instructables.com/id/RF-315433-MHz-Transmitter-receiver-Module-and-Ardu/?ALLSTEPS
They mention that i can use the PT2262 and PR2272 in the article without mentioning how to setup the code and hardware to use it(as far as i understand).
What is my question?
Maybe someone can help me successfully setup the hardware in fritzing and point me to the right direction on what libs i need to send code from the arduino?
I have the following setup: (i am actually using two different breadboards)
Thanks in advance!
About me:
I am rather new to electronics, so please be good to me
What am i trying to do:
I want to make this a cheap setup (don't mind the arduino cost) where i can have several transmitters and one receiver.
For example if i want to have a temperature sensor in 2 different places, and want to transmit the temperature to the receiver every hour.
Equipment i currently have:
- Arduino uno
- Arduino mega
- 433Mhz RF Transmitter / receiver (ebay)
- PT2262 (Datasheet1, Datasheet2)
- PT2272-M4 (Datasheet)
- Powersupply (0-30v)
- Breadboards, Wires, multimeters, different resistors, capacitators....etc
What have i already done successfully, and what is the problem?
I have setup the first transmitter and receiver code from here: http://www.instructables.com/id/RF-315433-MHz-Transmitter-receiver-Module-and-Ardu/?ALLSTEPS
They mention that i can use the PT2262 and PR2272 in the article without mentioning how to setup the code and hardware to use it(as far as i understand).
What is my question?
Maybe someone can help me successfully setup the hardware in fritzing and point me to the right direction on what libs i need to send code from the arduino?
I have the following setup: (i am actually using two different breadboards)

Thanks in advance!