M
Mathieu G
Hello,
I would like to design the electronics to use the Eltec 4202 quadrant
pyroelectric detector ( datasheet:
http://silverlight.ch/pdf/eltec_4202.pdf ) to detect the position of a
~100fs pulse width 1kHz repetition rate pulsed laser beam.
I would like to resolve each peak with the amplified signal to be within
[0;10]V
Yet I am unfortunately no expert in electronics, but willing to learn!
I would greatly appreciate if someone could help me define the basic
design to reach my goal, please.
Best regards,
Mat
I would like to design the electronics to use the Eltec 4202 quadrant
pyroelectric detector ( datasheet:
http://silverlight.ch/pdf/eltec_4202.pdf ) to detect the position of a
~100fs pulse width 1kHz repetition rate pulsed laser beam.
I would like to resolve each peak with the amplified signal to be within
[0;10]V
Yet I am unfortunately no expert in electronics, but willing to learn!
I would greatly appreciate if someone could help me define the basic
design to reach my goal, please.
Best regards,
Mat