Maker Pro
Maker Pro

Wanted: Push On Hook Clip Adapter

Status
Not open for further replies.
I'd imagine you can get the clips you solder wires to, for about $1 or $2 delivered from China, and the same for some banana plugs (providing you don't expect high quality for dirt cheap), then add whatever wire type and length you need.

You might also find assembled combinations of the above for cheap from China. $2.18 delivered:

https://www.ebay.com/itm/1Pair-Bana...le-For-Multimeter-Test-Equipment/121705584780

If they're not up to your standards, consider them a backup set and... it's only $2.

eBay is a jungle though, keep looking and there's more to be found, like a little cheaper or a generic version of what you wanted.

https://www.ebay.com/itm/1-Pair-4mm...-Probe-Lead-Cable-For-Multimeter/312193080704

https://www.ebay.com/itm/UT-C01-4mm...xtension-Hook-Probe-Testing-Clip/223085507422
 
Last edited:
Thanks gentlemen but the type I am looking for have a hole in their back end that you slip onto the pointy
end of the existing test lead. Only have one for one meter and on the second meter they are
the screw on type which takes sooooooooooo long to screw on and off. I don't want to have to
exchange the test leads that's a pain also.
 

Attachments

  • clip.JPG
    clip.JPG
    57.9 KB · Views: 8
My 3rd link was that type, and there are others on ebay too, cheaper than $24 a pair. Some are both push-on, and threaded to screw on at the end of the push-on range.
 
Status
Not open for further replies.
Top