Proteus Simulation

[JVMAPPY]

Hello Engineers;
I am currently designing a transmitter-Receiver wireless remote control mini project using Proteus 8.0
Professional.
During simulation I had three errors:
1. 'Cannot find model RX MDF'
2. 'Cannot find model TX MDF'
3. Simulation failed due to netlist error.

With some research I attached the Rx and Tx as Hierarchy module and the error was gone.

My only error now is " Simulation is not running in real time due to excessive cpu load"

I have closed all other programs running and my laptop spec is 64bit, 8gb Ram, 1Tb HDD.

Any help to resolve this will be well appreciated.

 

[Harald Kapp]

My only error now is " Simulation is not running in real time due to excessive cpu load"

So what? Is that truly an issue?
Simulations rarely run in real time as it takes multiple instructions the cpu to simulate a single step in time of a circuit.
Typically you simulate a circuit, record the simulation results and analyze the results later leisurely.

When you enter that message into your favorite search engine you will find that many people had the same issue - and received similar answers, even here on this forum.
It is always a good idea to first search what others may have to say on an issue before starting a thread.