Maker Pro
Maker Pro

Problems with PCB layout

PCB layout, in addition to the components on the schematic, can also add their own components? For example, digital ground, analog ground, single-point ground 0 ohms resistor, and magnetic beads, test points, etc. These are on the schematic diagram, or that the PCB layout engineer additionally added to? How to add?
 
Depends on the S/W being used, I use and am familiar with the free Kicad and you can add components as you wish.
For the physical layout, you would also need to provide a footprint.
 
Depends on the S/W being used, I use and am familiar with the free Kicad and you can add components as you wish.
For the physical layout, you would also need to provide a footprint.
I've been thinking about changing the software I use recently, and after hearing you say that, I think Kicad is a good choice.
 
Top