Power Supply from TODD Products Corp.

[Uwe Hercksen]

Hello,

i have here a defect power supply from TODD Products Corp. Brentwood,
N.Y. Model MDT-164-2415R
I would like to get some information about it, at least the output
voltages and currents. Are there replacement types from other companies?

Thanks a lot and bye

 

[Joerg]

Hello,

i have here a defect power supply from TODD Products Corp. Brentwood,
N.Y. Model MDT-164-2415R
I would like to get some information about it, at least the output
voltages and currents. Are there replacement types from other companies?

Todd Products has been acquired by SL Power about ten years ago:

http://www.slpower.com/

Their European outfit is in the UK and you can contact them about that
power supply. Since they also carry the Ault and Condor brands they
should be able to suggest an alternative power supply:

euinfo <at> slpower.com

If you get stuck send me a PM ("reply-to" address works), I know a good
contact person at SL/Condor. But I think it's best to find out what they
can supply in Europe, with power supplies that is sometimes restricted
because of RoHS and all that.

 

[legg]

Hello,

i have here a defect power supply from TODD Products Corp. Brentwood,
N.Y. Model MDT-164-2415R
I would like to get some information about it, at least the output
voltages and currents. Are there replacement types from other companies?

Thanks a lot and bye

http://www.slpower.com/UserFiles/File/MDT220.pdf

RL

 

[Uwe Hercksen]

http://www.slpower.com/UserFiles/File/MDT220.pdf

Hello,

thank you, the best match there is the model MDT-164-2412R, but I got
MDT-164-2415R. I guess there is an output with +15 V instead of +12 V,
but what about the -12 V, is it -15 V or -12 V?

Bye

 

[Joerg]

Hello,

thank you, the best match there is the model MDT-164-2412R, but I got
MDT-164-2415R. I guess there is an output with +15 V instead of +12 V,
but what about the -12 V, is it -15 V or -12 V?

Probably -12V. However, many Condor supplies can be adjusted between 12V
and 15V but you might have to crack through some sealing lacquer on a
trimpot. Sometimes a way to find out is to measure and compare the
resistors across the output because those set the feedback.

Best to send an email to them or call if you want to be sure.

 

[Uwe Hercksen]

http://www.slpower.com/UserFiles/File/MDT220.pdf

Hello,

do you know were to look for Model MDT-164-2415R? It is not mentioned in
the link from you.

Bye