Maker Pro
Maker Pro

Philips PM2525 service manual request

  • Thread starter Philippe Lemaire
  • Start date
P

Philippe Lemaire

Dear all,

has someone a copy of this manual to be made available ?
Or the instruction to proceed through the calibration ?


Thanks in advance,


Philippe
 
P

Philippe Lemaire

You know BAMA?

See user manual in

http://bama.edebris.com/manuals/philips/pm2525/

Greetings


Thanks !

I previously downloaded it just in case it was not the user manual
but the service manual.

Unfortunately, it was the user manual which I already have on paper :-
( !

The service manual seems far more difficult to find...
And Fluke will not calibrate it even for money !


Regards,


Philippe
 
O

otro JJ

G

G. Canale

Hi to all.
I downloaded the service manual from FSM
Unfortunately it is missing of one page that is important to me, chapter 5
page14 15.
I am in trouble because my PM2525 indicates NC ( non calibrated ) on all
ranges.
Usually this is due to to the internal back up battery that in my case seems
in good conditions.
I have tried the calibration, it seems that there is a sequence to follow in
the calibration
but due to the missing page I do not know it.
Any suggestion
Thanks for the help
Gianfranco
 
P

Philippe Lemaire

Hi to all.
I downloaded the service manual from FSM
Unfortunately it is missing of one page that is important to me, chapter 5
page14 15.
I am in trouble because my PM2525 indicates NC ( non calibrated ) on all
ranges.
Usually this is due to to the internal back up battery that in my case seems
in good conditions.
I have tried the calibration, it seems that there is a sequence to follow in
the calibration
but due to the missing page I do not know it.
Any suggestion
Thanks for the help
Gianfranco

They are missing in my copy too :-( !

I also have the NC display but have still not tried with
recalibration.

Hopefully, this page is somewhere...



Philippe
 
G

G. Canale

I tried the calibration that is very time consuming.
I started with calibration of DC voltage, 2V.
I made the cold calibration and the hot calibration.
Everything vas OK.
Then I went out of the calibration procedure and returned to the measurement
..
The NC is still there.
I do not understand why.
I suspect that the calibrations must be done in a defined sequence but I
dont know which and the page in the manual is missing.
I am trapped.
Any suggestion ?
 
Top