A
Andrew Holme
I want to use an old board as a starting point for a new one; but the old
one has a problem: length minimize doesn't work on the GND net. Other nets
are OK; but I'm getting lots of GND rats needlessly crisscrossing the board
after I ECO in the changes. The only way to get rid of them is to actually
route GND pins. Anyone seen this? I have other designs that are not
affected but I don't know what it is about this particular board.
TIA
one has a problem: length minimize doesn't work on the GND net. Other nets
are OK; but I'm getting lots of GND rats needlessly crisscrossing the board
after I ECO in the changes. The only way to get rid of them is to actually
route GND pins. Anyone seen this? I have other designs that are not
affected but I don't know what it is about this particular board.
TIA