Maker Pro
Maker Pro

Open-circuit Req Circuit

I have tried to put it into LTspice, but cannot get it to run. I have tried grounding the open circuit ends, but that doesn't seem to work.
 

Harald Kapp

Moderator
Moderator
I have tried grounding the open circuit ends, but that doesn't seem to work.
You need one single ground only. Using multiple grounds will short circuit these parts of the circuit. Show us your LTSPICE diagram or upload the .asc file for inspection.

Provided you get the simulation up and running: how will you determine the equivalent resistance from the simulation?
 

Harald Kapp

Moderator
Moderator
No.
What is the usual way to determine the resistance of a component? Hint: what is the equation for R = ??? in terms of voltage and current?
 
I need assistance with this problem. I cannot seem to figure it out.

Ridiculously simple. Redraw the circuit.
Capture.JPG

Then use any generic equation solver or pencil and paper to solve the loop equations with a 1 volt source.



Capture2.JPG

1 volt gives 1/25 amp so the resistance is 25 ohms.

Ratch
 
Top