-
Categories
-
Platforms
-
Content
davenn
Moderator
hi there
welcome to EP
firstly, it's a really good idea to draw circuits in the "normally correct" orientation ie. in on the left and out on the right
Did you actually try and google an answer ?
http://www.rfcafe.com/references/electrical/opamps.htm
http://www.radio-electronics.com/info/circuits/opamp_basics/operational-amplifier-gain.php
http://www.electronics-tutorials.ws/opamp/opamp_2.html
there's 3 of dozens of hits on google
I would let you look through them and others
Dave
welcome to EP
firstly, it's a really good idea to draw circuits in the "normally correct" orientation ie. in on the left and out on the right
Did you actually try and google an answer ?
http://www.rfcafe.com/references/electrical/opamps.htm
http://www.radio-electronics.com/info/circuits/opamp_basics/operational-amplifier-gain.php
http://www.electronics-tutorials.ws/opamp/opamp_2.html
there's 3 of dozens of hits on google
I would let you look through them and others
Dave
This sounds like homework.
The way to analyze op amp circuits is to determine an equation for the + input and one for the - input. To a good approximation, these will be equal, because, if not, the difference will be multiplied by 1,000,000 or more and sent to the output, which will put the output at the + or - rail.
So write down the two formulae for the + and - inputs, then equate them, and you should have an equation for involving Vout, Vin1 and Vin2. For the 5V case, just substitute 5 for Vin1. Then solve for Vout.
Bob
The way to analyze op amp circuits is to determine an equation for the + input and one for the - input. To a good approximation, these will be equal, because, if not, the difference will be multiplied by 1,000,000 or more and sent to the output, which will put the output at the + or - rail.
So write down the two formulae for the + and - inputs, then equate them, and you should have an equation for involving Vout, Vin1 and Vin2. For the 5V case, just substitute 5 for Vin1. Then solve for Vout.
Bob
CDRIVE
Hauling 10' pipe on a Trek Shift3
davenn
Moderator
It's possible that he did and fortunately got a hit on EP.
Chris
which I didn't see and why I gave several links for him to follow up on
CDRIVE
Hauling 10' pipe on a Trek Shift3
I guess my point is we never know what new member might someday be an EP shining star. So we should be glad when they decide to check here first. We have more than enough collective brain power to help them without directly doing their homework.
After all, many of us may deny this but reality is most if not all EP VIP contributors are here because we have IMMENSE egos. Except me of course! I'm humble..
Chris
After all, many of us may deny this but reality is most if not all EP VIP contributors are here because we have IMMENSE egos. Except me of course! I'm humble..
Chris
Which gain? The gain of v1 or v2? Incremental gain or static gain? r1, r2, and v1 sets the voltage at the + and - terminals of the op-amp. Then is a simple matter of solving a node equation as shown below.
Ratch
Similar threads
