This device came out of a scanning electron microscope.
on the case it say's HIGH Voltage & variable emission,
the components look like 70"s era.
it was connected to the electron beam generator on the microscope.
So my guess is that it switches the variable output to the
beam gun. but what's inside those red blocks?
each one connects to the next one in series through the big connectors
near the tops of the red blocks. they also all connect to a heavy circuit board at the bottom.
on the control panel there was a power selection module with 5 setting's (30KV, 20KV, 10KV, 5KV, 2.5KV)
So maybe each red block doubles the voltage? how?
Does anyone Know more about this thing?
whats in the red blocks?
can I use it to maybe make a spot welder?
on the case it say's HIGH Voltage & variable emission,
the components look like 70"s era.
it was connected to the electron beam generator on the microscope.
So my guess is that it switches the variable output to the
beam gun. but what's inside those red blocks?
each one connects to the next one in series through the big connectors
near the tops of the red blocks. they also all connect to a heavy circuit board at the bottom.
on the control panel there was a power selection module with 5 setting's (30KV, 20KV, 10KV, 5KV, 2.5KV)
So maybe each red block doubles the voltage? how?
Does anyone Know more about this thing?
whats in the red blocks?
can I use it to maybe make a spot welder?



