S
sunnie
I hope that someone can help me here
I have a Kit 149 Version B Pic Programmer
I have dloaded the reqiuired file as per the instructions
I ran the programmer and software as per the instructions and
with a chip i think maybe zapped with static i got he following results
When i put the chip in to the progammer and verify i get
ROM DATA
3fff at every address
EEPROM DATA
FF at every address
When i do an erase
ROM Programming error at address 0x0001
Verify = ROM error at 0x0000
Good 0x1e03
Bad 0x3fff
When i blank the chip i get an error stating ID FUSE programming error
So i put a new chip in ad made sure that i used an appropiate tool and i was
able to get the rom data and the eeprom data to show 0000 in all the
addresses
I then was able to verify and clear the chip with no problems
When i went to program the chip i got the same error as above
ROM Programming error at address 0x0001
Have i comiled the file in a wrong compiler
Have i not put in an address range
Or is it a programmer error
Would love to get some positive feedback on this
and yes i do know the dfference between
So i have gone and bought a new pic chip and yes it is a 16f84
And i followed the instructions and i get the same error message as before
ROM Programming error at address 0x0001
I have a Kit 149 Version B Pic Programmer
I have dloaded the reqiuired file as per the instructions
I ran the programmer and software as per the instructions and
with a chip i think maybe zapped with static i got he following results
When i put the chip in to the progammer and verify i get
ROM DATA
3fff at every address
EEPROM DATA
FF at every address
When i do an erase
ROM Programming error at address 0x0001
Verify = ROM error at 0x0000
Good 0x1e03
Bad 0x3fff
When i blank the chip i get an error stating ID FUSE programming error
So i put a new chip in ad made sure that i used an appropiate tool and i was
able to get the rom data and the eeprom data to show 0000 in all the
addresses
I then was able to verify and clear the chip with no problems
When i went to program the chip i got the same error as above
ROM Programming error at address 0x0001
Have i comiled the file in a wrong compiler
Have i not put in an address range
Or is it a programmer error
Would love to get some positive feedback on this
and yes i do know the dfference between
So i have gone and bought a new pic chip and yes it is a 16f84
And i followed the instructions and i get the same error message as before
ROM Programming error at address 0x0001