S
shdwkeeper
I just purchased a P3200 Panel Along with the NAPCO K4RF Keypad
w/Built-in 32-pt RF Receiver. I'm using this for all the wireless
transmitters. I'm having problems setting this up. When I first
powerup the panel and keypad, the keypad starts counting from 1-8
repeatedly until its starts beeping and the display says trouble. When
I get into the Easy Setup and try to Auto Configre the transmitters it
doesn't work. I am probably doing something wrong. I was told to get
into easy setup go to programming mode 28 hit the bypass button,
(red&green lights on keypad flash) insert battery into transmitter and
it should auto configure. I'm just trying 1 transmitter right now to
test this.
Does anyone have a step by step that is less confusing then the manuals
that come with this Panel 3200. What am I doing wrong? After I program
the 1 transmitter into the system how can I test it? I hit the reset
button twice and it resets the panel and this scenario starts all over
again with the beeping.
Any help would be appreciated.
Thanks.
w/Built-in 32-pt RF Receiver. I'm using this for all the wireless
transmitters. I'm having problems setting this up. When I first
powerup the panel and keypad, the keypad starts counting from 1-8
repeatedly until its starts beeping and the display says trouble. When
I get into the Easy Setup and try to Auto Configre the transmitters it
doesn't work. I am probably doing something wrong. I was told to get
into easy setup go to programming mode 28 hit the bypass button,
(red&green lights on keypad flash) insert battery into transmitter and
it should auto configure. I'm just trying 1 transmitter right now to
test this.
Does anyone have a step by step that is less confusing then the manuals
that come with this Panel 3200. What am I doing wrong? After I program
the 1 transmitter into the system how can I test it? I hit the reset
button twice and it resets the panel and this scenario starts all over
again with the beeping.
Any help would be appreciated.
Thanks.