Hello everyone I am Ade i know you guys get asked for help a lot so hopefull you can help me
My company have given me a small project basically to find out what voltage a 58W 110v fluorescent fitting will strike at. So how can i go about this and what can i make to do this.
My initial thoughts were to get either 2 variable resistors (or one duel variable resitor if they exist) one for L1 and one for L2 connecting in a voltage indicator on the 110v steady side so i can visably see that i have 110v constant and on the other side of the resistors another voltage indicaticator so that as i reduce the voltage then i can see a change and see what voltage i go down to before the fitting fails.
I am not sure what variable resitors i need or even if this is the correct way of doing this. Any advice or suggestions would be greatly received
Thank you
Ade
My company have given me a small project basically to find out what voltage a 58W 110v fluorescent fitting will strike at. So how can i go about this and what can i make to do this.
My initial thoughts were to get either 2 variable resistors (or one duel variable resitor if they exist) one for L1 and one for L2 connecting in a voltage indicator on the 110v steady side so i can visably see that i have 110v constant and on the other side of the resistors another voltage indicaticator so that as i reduce the voltage then i can see a change and see what voltage i go down to before the fitting fails.
I am not sure what variable resitors i need or even if this is the correct way of doing this. Any advice or suggestions would be greatly received
Thank you
Ade