T
Tom
I am looking for a low cost dual output DC power supply design with the
following requirements:
-input voltage 4.75 vdc to 30 vdc (must be able to work throughout the
range)
-output voltage +15 vdc and -15 vdc
-output current requirement 25 mA maximum (anything over this is overkill)
-relatively noise free output (ie. ideally less than 10 mV
To date we have looked at using a DC to DC converter for this application
but the startup current, although brief, is way beyond the 25 mA maximum
which makes it unacceptable.
We are also looking at a design that uses a Linear Technology LTC1871 chip.
This device shows promise but we are experiencing severe noise problems.
A complete design or any suggestions you might have on using the LTC1871
chip to do this job would be most appreciated.
following requirements:
-input voltage 4.75 vdc to 30 vdc (must be able to work throughout the
range)
-output voltage +15 vdc and -15 vdc
-output current requirement 25 mA maximum (anything over this is overkill)
-relatively noise free output (ie. ideally less than 10 mV
To date we have looked at using a DC to DC converter for this application
but the startup current, although brief, is way beyond the 25 mA maximum
which makes it unacceptable.
We are also looking at a design that uses a Linear Technology LTC1871 chip.
This device shows promise but we are experiencing severe noise problems.
A complete design or any suggestions you might have on using the LTC1871
chip to do this job would be most appreciated.