Multiple voltage supply

[captoro]

Hello I am using the PSPice Orcad

I have many drivers with the same voltage. Is there a way to do the
simulation with only that voltage and use reference point to that
voltage instead of using multiple line from the source to each driver.
This would reduce a lot the amount of lines and would make things much
clearer.

THANKS,

k

 

[qrk]

Hello I am using the PSPice Orcad

I have many drivers with the same voltage. Is there a way to do the
simulation with only that voltage and use reference point to that
voltage instead of using multiple line from the source to each driver.
This would reduce a lot the amount of lines and would make things much
clearer.

THANKS,

k

You can use net names. All wires with the same net name will be
connected in the net list.

 

[Charlie E.]

I'm assuming Capture... don't you also need to turn on "connectivity
via labels", same as in PSpice Schematics? Although I can recall some
really bizarre label behavior in Capture... like losing node "0"
because I dared to label it "GND" :-(

...Jim Thompson

there are also teh power and ground symbols that name the net
automatically, but lets you represent the power supplies they are
attached to. Find under Place/Power and Place/Ground